- Make sure the frame on
which the unit is going to be mounted is rigid. The mounting surface
should also be clean and flat.
- Make sure that the end
of the shaft is free of any burrs. (Fig. 3)
- The end of the set screw
in the eccentric collar should not protrude into the bore of the collar.
- Insert the shaft into
the bore of the bearing.
- Mount the housing of the
unit using the appropriate bolts.
- Match the eccentric
groove on the collar with the eccentric groove on the bearing inner
ring.
- Turn the collar by hand
in the direction of shaft rotation. (Fig. 4)
- To set the collar,
insert a punch into the hole in the O.D. of the collar. Tap the punch so
that the collar turns in the direction of shaft rotation. (Fig. 5)
|
|
Figure 3
Figure 4
Figure 5
|
