Set Screw Mounting

1. Make sure the support for the bearing unit is rigid and the surface where the unit is going to be mounted is clean and flat
2. Make sure that the end of the set screw is not protruding into the bore of the bearing insert.
3. Make sure that the end of the shaft is free of any burrs.
4. Insert the shaft into the bore of the bearing. (Fig. 1)

Figure 1

5. Do not strike the seal or subject the unit to any shock loads.
6. Mount the housing using the appropriate bolts
7. Insert a wrench securely into the hole of the set screw, and tighten the two screws uniformly. (Fig. 2)

Figure 2